Flexs Q5 DC Power Distributor

$35.00

Converts the Flexs Q5’s 8 relay switches into 8 switched dc power ports which draw power from the 2 pin screw terminal. Allows for simplified installation removing the need for a separate bus bar when all loads can be powered from a common source. Do not purchase the part if you require low side switching or more complicated switching configurations.

SKU: ACC-Q5-DIST15A Categories: ,

Additional information

Weight 1 lbs
Dimensions 12 × 12 × 6 in

Related products

  • High Voltage Reducer (HV10M)

    $40.00     Add to cart

    High Voltage Reducer (HV10M)

    The new din-rail mountable High Voltage Reducer (HV10M) enables the FlexSCADA Q5 to measure voltages beyond 60 volts. The redesigned HV10M allows users to monitor more inputs and increases the maximum voltage range from 60V to 300V. HV10M connectors are rated to 300V and the voltage scaling components are rated to 1.5kv, providing protection against large surges and
    transient events.
    Utilizing the upgraded HV10M, the FlexSCADA Q5 can now monitor voltages from each of the eight (8) analog inputs. Input lines can be connected directly to the terminal blocks and into the HV10M, eliminating the need to remove the terminal block to connect input wires to the high voltage reducer. The improved HV10M is also physically larger than the original version, both to facilitate din-rail mounting and to allow the unit to accept larger gauge input wire. As voltage reduction occurs within the unit, large gauge wire is not required to connect the HV10M to the analog input of the FlexSCADA Q5.

    SKU: ACC-Q5-HV10M Category:
    $40.00

  • Flexs Q5 High Voltage Reducer

    $40.00     Add to cart

    Flexs Q5 High Voltage Reducer

    This inline voltage reducer is designed to all you to measure voltages beyond 60V from the Flexs Q5. It connects inline between your voltage source and the input channel on the Flexs Q5 increasing the maximum voltage range from 60V to 300V. The connectors are rated at up to 300V and the voltage scaling components up to 1.5kv providing protection against large surges and transient events.

    SKU: ACC-Q5-HVIN Categories: ,
    $40.00

  • Waterproof Digital Temperature Sensor Probe 3 meter

    $29.00     Add to cart

    Waterproof Digital Temperature Sensor Probe 3 meter

    The DS18B20 is a ULTRA HIGH resolution LOW POWER digital temperature sensor, these are pre-installed into a rugged and waterproof stainless steel enclosure allowing for a variety of installation scenarios. These sensors each contain unique address allowing up to 32 of them to be directily connected to our Flexs series PLC’s with only 3 wires

    SKU: ACC-TEMP3M Category:
    $29.00
Menu